森云智能用户6236
Operation Instructions for Direct Connection between [SENSING CCG3 ] and [IPC ] - PTP Time Synchronization
输入“/”快速插入内容
Operation Instructions for Direct Connection between [SENSING CCG3 ] and [IPC ] - PTP Time Synchronization
Operation Instructions for Direct Connection between [SENSING CCG3 ] and [IPC ] - PTP Time Synchronization
用户6236用户62363月6日修改
1.
Overall structural block diagram
画板
2.
Hardware environment confirmation
2.1
Confirm that the connection between the industrial computer and the acquisition card is OK.
Connect the ETH port of the acquisition card to the ETH0 port of the industrial computer using the "Aviation Plug to Network Cable" attached to the lower layer of the acquisition card packaging box.
2.2
Confirm that the industrial computer can recognize the acquisition card
After correctly inserting the CCG3 acquisition card into the PCIE3.0 interface, you can execute the " lspci | grep Xi " command to confirm whether the acquisition card is installed. The following indicates that the industrial computer correctly recognizes the acquisition card.
2.3
Confirm that the industrial computer can ping the acquisition card
Set the IP of [ETH0] of the industrial computer to [192.168.2.xxx] to ensure that the IP [192.168.2.11] of the acquisition card is in the same network segment and does not conflict.
Industrial control computers can refer to the following settings for fixed IP.
代码块
Address：192.168.2.32
natmask：255.255.255.0
Gateway：192.168.2.1
Execute the " ping 192.168.2.11 " display result, if it shows the following: time = 0.138 ms means that the acquisition card has been pinged.
2.4
Confirm the Ethernet slogan of the industrial control computer
Execute the "ifconfig" command as follows. When you see the website slogan "ETH0", it corresponds to "eno1".
3.
Software environment settings
3.1
Confirm that the program inside the acquisition card is the latest version, and the current shipment is the latest version. (The original 1.0.xxx version is not supported)
3.2
Enter the following path and execute the following two instructions.
3.3
Enter the SDK package with the following path